Help please, oil drain plug won't budge

[heff]

[quote=68ramair;2323620]

Originally Posted by heff

Try using a single hex socket not the twin hex on open end wrenches as this will give you more surface area on the flat and corner. Sometimes trying to tighten first then back off works as it breaks the surface tension. Good luck mate.
Heff[/QUOTE

You mean a 6 point as opposed to a 12 point?

Correct as it is less likely to round off the corners.
Heff

[Mike7202]

Originally Posted by heff

Sometimes trying to tighten first then back off works as it breaks the surface tension. Good luck mate.
Heff

i always heard you aussies were upsidedown and backwards