Hey bud. Ivans sending my ECU back, it's finished. He doesn't have a map for the cams we have so we will have to take it to be dyno. So that means more cost for us. He hasn't got his hands on bikes like ours yet to give a proper map. I'm kinda bummed about it. I hope this works well with our set up. I'm concerned.
Do you think I will need new cables for ape with this dimensions? I am putting them on a 2002
THESE ARE KNURLED 4.5" CENTER TO CENTER
•ARE PRE DRILLED FOR WIRING
• 1 1/4" TUBING STEPPED DOWN TO 1" TUBING WITH A .120 WALL THICKNESS.
•34" BAR TIP TO BAR TIP
•12" UP RISE
•6.5" OF PULLBACK
•7-1/2" TUBING FOR CONTROLS
•Total inside side to inside at bottom 7.5"