GEE, WHERE DO I START
-Performance EDGE Single Sided Swingarm
-RC Components "Gladiator" chrome rims (Rear is 18 x 8.5, Front is 19 x 3.0)
-RC Components polished stainless steel dual front rotors with chrome bolts
-RC Components chrome rear pulley rotor w/braided brake line
-Metzeler ME 880 260mm Rear Tire
-Yamaha Speed STAR FULL Performance Engine Modification with Speed STAR IV ECU
-Power Commander III USB
-Custom dyno tuned map installed
-BUB Rhinehart exhaust
-Performance EDGE 23 blue LED light kit installed (69 led bulbs total)
-Yamaha Chrome push rod covers
-Yamaha Chrome fork tube covers (removed)
-Yamaha Chrome fork fork caps
-Yamaha Chrome billet steering stem nut cap (removed)
-Yamaha Chrome front axle covers
-Yamaha Chrome billet neutral cover
-Yamaha Chrome starter cover
-Yamaha Chrome alternator cover
-Yamaha Chrome clutch cover
-Yamaha Chrome frame inserts
-Yamaha Chrome fender rails
-1.5" CarliniHandlebars internally wired
-Barons chrome oil filter cover
-Barons naked pulley cover with insert
-Barons hidden rear brake reservoir
-Barons chrome front master cylinder cap
-Barons chrome grips
-Performance EDGE Chrome brake and clutch lever
-Speigler braided front brake lines with chrome banjo bolts
-CorbinYoung Gunsseat (Croc/Ostrich/Shark)
-Powder coated black speedo/tach cover (removed)
-Powder coated black upper/lower triple tree (removed)
-Powder coated black foot peg brackets and levers (removed)
-Integrated rear turn signal in taillight with additional resistors
-Paul Yaffe "Power Mirror " and "Power Arm"
-Chrome license plate frame with blue LED illumination light
-Tricky infinately adjustable ride height air shock
-Tricky air ride up/down remote
-Yamaha braided s.s. throttle cables 2/27/06
-Yamaha braided clutch cable 2/27/06
-Yamaha flamed chrome transfer case cover 3/05/06 (thanx Darkstar)
-Kuryakyn pilot pegs 2/27/06 (removed)
-Kuryakyn passenger pegs 2/27/06
-Kuryakyn shift and brake covers 2/27/06(removed)
-Cal Customs sword shift linkage 2/27/06
-Rear brake switch relocation 3/14/06
-Horn relocation 3/14/06
-.44 Mag fork nut covers 7/5/6
-Left and right side Barons teardrop enferno side covers 11/26/06
-Phats Forward Controls 11/26/06
-oil pressure gauge 11/26/06 (Thanx Darkstar)
-Dry break relocated under tank 11/26/06 (Thanx Woody, A.K.A Churchkey)
-Fuel pressure regulator relocated under tank (Thanx Woody, A.K.A Churchkey)
-Ignition bypassed 10/08
-14 degree front end rake with 65mm inverted forks by Chopper Kit USA 10/08
Stay Tuned.... There's more to come
Special Thanks to:
Matt (CBRMAT) and the crew @ PerformanceEdge
WWW.PERFORMANCEEDGE.US .
Matt @ Phats Performance Parts
www.Phatsperformanceparts.com
Greg @ chopper kit usa
www.chopper-kit-usa.com
...
.
About Me
