RS Warrior Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
29 Posts
Discussion Starter · #1 ·
I am installing my load equalizer, well trying to, but I lost instructions. It has three wires coming out of it, blue, tan, and black. Does any body know which goes where. I can figure the black out. lol.


Thanks,


Ed
 

·
Premium Member
Joined
·
1,088 Posts
they go to the right (dark green wire) and left (chocolate brown)turn signal wires, does not matter which one (blue or tan). black is ground. all it does is add resistance to the circuit, do doesn't matter which goes where.


load eq'sare wired in parallel, so they "T" into the turn signal wires.


front or back does not matter, i got ahold of my wiresby the ecu, but that was just where i was working at the time. good ground is important.
 

·
[Retired Admin-SuperMod]
Joined
·
30,718 Posts

·
Registered
Joined
·
29 Posts
Discussion Starter · #4 ·
Thanks guys. I got it all installed. Installed my new rear turn sigs too. Took me awhile but she is done! I put my load eq under seat, left side of battery box. It fit in there very nice. Hope it all holds up good, 100 mile poker in morning!


Thanks,


Ed
 
1 - 4 of 4 Posts
Top