RS Warrior Forum banner

Baron's Swing Arm

2.1K views 17 replies 8 participants last post by  DFW_Warrior  
#1 ·
Okay guys, I need you help once again. [/emoticons/emotion-2.gif]

I am looking at the Baron's Swing Arm for my 2006 Warrior and wanted to ask a couple questions.

1. Can anyone confirm a 260mm tire will fit on this bad boy.
2. They state if I have a stock fender the largest tire I can use is a 210mm. Is this true or would they just be restating Yamaha's point of view?

Also, if you can think of any reason this might be a bad mod for my bike please let me know.

Nitrors4
a.k.a Troy
 
#2 ·
you can fit a 260 tire under the fender Let be honest a 260 metzler 880 series tire. The Barons swingarm weights 4 times what the cycleimage/performanceedge.us swingarm does(mind you its only about 20lbs regardless). When i got my 280 swingarm from CI i was shocked how light it was.. Felt like plastic. As for being a bad mod no its a great mod and lots of people have done it. As for the 260 tire fitting yes it will because its smaller accross than the 250 dunlop and that fits
 
#3 ·
Not sure, I want to hear it weighs four times as much as a modified swing arm. [/emoticons/emotion-4.gif] Now with this weight do I gain strength? I am being offered the Baron's Swing Arm from another member, for a good price and was trying to decide which way I should go. I could go with CI or PE and get a modified arm, but I though this one would give me a little more of a custom look.

Thoughts?


quote:Originally posted by ohiomike

you can fit a 260 tire under the fender Let be honest a 260 metzler 880 series tire. The Barons swingarm weights 4 times what the cycleimage/performanceedge.us swingarm does. As for being a bad mod no its a great mod and lots of people have done it. As for the 260 tire fitting yes it will because its smaller accross than the 250 dunlop and that fits
 
#7 ·
AS far as your tire fitting, it all depends on how much you are lowered. My Avon 250 (skinnier than the dunlop or 260) fit with tricky air ride and very minor massaging of the under fender support. The width should fit but the height may be an issue. As far as it weighing more. yes it weighs more...4x not sure it's that much. Also If you ever want to put a chain on it w/ TAR the stock modified arm will most likely rub. With my stock arm the belt ever so slightly touched with the TAR.
 
#15 ·
quote:Originally posted by ehacker01

quote:Originally posted by ohiomike



Here is the size breakdown for comparison:
Metz 240mm 9 1/4" wide
Avon 250mm 9 1/2" wide
Metz 260mm 9 7/8" wide
Dunlop E3 250mm 10" wide
I got the from PE


280mm 12 3/8 pic in my gallery with tape
What's the metz 280?