RS Warrior Forum banner

41 - 48 of 48 Posts

·
Registered
Joined
·
157 Posts
Where do you can find this kind of ttbar?

its been a few months I'm looking at different site to make me a clean dragbar but with a small riser, I can not find. . .
What is the minimum required for a riser right dragbar 1 1/4 or 1/2 "?

arno
 

·
Registered
Joined
·
3,911 Posts
Where do you can find this kind of ttbar?

its been a few months I'm looking at different site to make me a clean dragbar but with a small riser, I can not find. . .
What is the minimum required for a riser right dragbar 1 1/4 or 1/2 "?

arno
Probably just welded some drag bars on top of a pair of risers. :eek: It's going to be a rather long reach though.
 

·
Registered
Joined
·
845 Posts
Where do you can find this kind of ttbar?

its been a few months I'm looking at different site to make me a clean dragbar but with a small riser, I can not find. . .
What is the minimum required for a riser right dragbar 1 1/4 or 1/2 "?

arno
This is by far my favorite of all these bikes. Most look cool but whats the point if you cant ride them? I would rather ride than just look at the bike.
 

·
Registered
Joined
·
3,911 Posts
The bar may also hit the tank when turning the front end.
This is true but you could experiment with the height of the riser before welding the top bar on. I would be very careful about making bars though, can you imagine how much stress would be put on the bottom mounting nuts when slamming on your brakes?
 
41 - 48 of 48 Posts
Top