RS Warrior Forum banner
  • Warrior of the Quarter Challenge 23Q1! Enter your bike HERE
1 - 2 of 2 Posts

· Registered
1,930 Posts
badger I will do it for you. Just to let you guy's know the pre drilled holes located where the throttle side and the clutch side are not in the proper location and you will have to drill new holes about one inch away from the existing one's that are useless because the left side mirror mount and the right side brake resevior, cover the holes that they so carelessly put in. You will have to drill file and or dremmel to run internal wireing even though they fit the warrior mounting holes on the tripple trees.They look good once you get them on but pulling those wires through the left side will try your paitence,because that 90 degree turn has a nice sharp edge sticking up inside the bars.And dont forget to put the left side mirror on first before you pull those wires through.I hope this helps.Mike
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.