RS Warrior Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
410 Posts
Discussion Starter · #1 ·
I just purchased a set of Cruiser Performance 1120s...these are the ones with 13' of pullback. Now, I have two (maybe three) questions and was hoping for some help.


1- Will I have to buy longer throttle or brake cables to fit these?


2- Will I have to extend the wires to fit these? If so, what is the best way to do this?


As usual, thanks in advance for any and all help you guys can give me.
 

·
Registered
Joined
·
6,075 Posts
1 Your existing throttle, brake and clutch lines will work.

2 The wires will fit, but it's a bit of a stretch. If you internally wire the bars (why wouldn't you?), you'll end up extending your wires anyway.
 

·
Administrator
Joined
·
30,093 Posts
Are these the Cruiser Performance bars? Nice bars. They can be internally wired? Very nice.


The cable 'path-math' has them at least an inch longer run stock path.


The extra inch must fit fine, Ray has 'em. You both have'02's.


Specs:

[*]8 inch Risers
[*]12 inches of Pullback
[*]Top Handle Bar is- 33 inches wide





Compare to stock:


Handlebars - Stock - 2002-2003: 11-1/2" pullback 34" wide 6" rise
Handlebars - Stock - 2004-2008: 13" pullback 34" wide 5-1/2" rise
 
1 - 3 of 3 Posts
Top