RS Warrior Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
1,810 Posts
Discussion Starter #1
Noticed that the top of my pipe is starting to yellow. Must be running to lean. Tried to reproprogram my ECU as per instructions on warrior.roadrider.org. All I got as a display message was ER-1. Any suggestions. Also my #27 wire looks like its already been spliced.[?]
 

·
Registered
Joined
·
79 Posts
What do you mean spliced?

Not sure what you've tried. I was just in my ECU. Click wire #27 out of the connector by pressing the white strip on the connector out to one side. Pull out just wire #27. Click the white strip back into place. Plug the connector back to the ECU. Ground #27 to the frame. Hold down both buttons on the tach and turn the key on. Hold for 8 seconds or so...and so on.

Is that what you're doing?
When do you see the error?
 

·
Registered
Joined
·
1,810 Posts
Discussion Starter #4
Thanks Kenwood, Must have had a brain fart, left the ECU sitting on the workbench, there's the reason for my error message.

Thanks and ride safe
 

·
Registered
Joined
·
3,106 Posts
quote:Originally posted by Monstrddg

Ill bet 1/3 of all the people that do an ecu adjust forget to plug it back in on the first time they try


I'll bet at least a 1/3 of all of the people that do an ecu adjust with they bought a PCIII [/emoticons/emotion-5.gif]...
 
1 - 7 of 7 Posts
Top